====== Introduction ====== The goal of this program is to detect and decipher one or several QR codes in a picture. ====== Required Libraries ====== In order to decipher QR codes, we will use the zbarlight library, installed (on Debian) as follows:\\ ''apt-get install libzbar0 libzbar-dev''\\ ''pip install zbarlight''\\ We will also use a number of standard Python libraries. from PIL import Image import zbarlight from subprocess import Popen, PIPE import sys import datetime ====== Explanation ===== The program allows exactly one argument: the IP address of the Raspberry Pi whose camera we're going to be using.\\ To avoid any issue, we check that it is a valid IP address with the following function: def isValidIPV4(adr): nums = adr.split('.') if len(nums) != 4: return False try: return all(0 <= int(num) < 256 for num in nums) except ValueError: return False If the right argument was given, we can remote into the pi to take a picture. To do so, we use subprocess.Popen() to run the following command with the given ip:\\ ''ssh -t pi@ "raspistill -hf -vf -o --nopreview --timeout 10"''\\ To avoid conflict with an already existing picture, we put the date and time in the new picture's name. if (len(sys.argv) == 2 and isValidIPV4(sys.argv[1])): filename = 'qrcodereader_' + datetime.datetime.now().strftime("%Y-%m-%d-%H:%M:%S") + '.jpg' print("Taking picture...") command = ['ssh', '-t', 'pi@' + sys.argv[1], "raspistill -hf -vf -o " + filename + " --nopreview --timeout 10"] x = Popen(command, stdout=PIPE, stderr=PIPE) stderr = x.stderr.read() print stderr We then import the resulting image over ssh using the ''rsync'' command. print("Importing...") command = ['rsync', '-avz', '--ignore-existing', '--remove-source-files', 'pi@' + sys.argv[1] + ':~/' + filename, '/home/silver/BE/' + filename] x = Popen(command, stdout=PIPE, stderr=PIPE) stderr = x.stderr.read() print stderr We now simply use zbarlight to decode any and all QR codes fully visible on the picture. We only need to open and load the image, before applying the scan_codes function. file_path = './' + filename with open(file_path, 'rb') as image_file: image = Image.open(image_file) image.load() code = zbarlight.scan_codes('qrcode', image) print('QR codes: %s' % code) The program outputs a full list of all deciphered QR codes.